Snow Performance Stage 3 EFI 2D Map Progressive Water Injection Kit

Snow Performance Stage 3 Boost Cooler

The Snow Performance Stage 3 Boost Cooler brings true two-dimensional mapped water-methanol injection delivery to your EFI (electronic fuel injected) and forced induction (turbocharged/supercharged) vehicle. The Stage 3 creates a two-dimensional injection map based off boost and fuel injector pulse width to deliver an extremely accurate amount of water-methanol when the engine needs it most.

Bringing fuel injector pulse width into the mix allows the injection curve to be extended past specific boost points for greater range/control. Non-invasive, the Stage 3 Boost Cooler controller is designed to mount on the steering column or the dash so no additional gauge pods need to be purchased and functions as a boost gauge, water-meth controller, and fuel system monitor all in one! Proven to reduce the air inlet temperature by up to 100 degrees and increase octane by 25 points for maximum HP and cooling.

Comes with adjustable Stage 3 water-meth controller, 1/4″ High Temp Nylon line, and easy-to-install quick-connect fittings.

Features:

• Two-dimensional injection map
• Reduce air intake temps out to 100 degrees
• Increase octane by 25 points
• Cleans all carbon buildup out of your motor
• New nozzle design
• Built-in boost gauge
• Lower EGTS

Snow Performance Warranty

For information on Snow Performance’s warranty terms and conditions, please click here.

Purchase Disclaimer: You are hereby informed and warned to check your local, state, and federal laws before buying and installing these or any aftermarket parts to be sure whether usage is in violation. All installation-risk and use-risk is borne by the end-user and installer of these parts. Bolt Motorsports does not condone the use of emission defeat devices for any vehicles used on public streets or roadways. Bolt Motorsports will not tamper, remove, disable, or bypass emissions equipment on a motor vehicle in accordance with 40 CFR Section 86.1854.12(a)(3), Clean Air Act 40 CFR 1068.101(b). This includes software, known as tunes, that reprogram a motor vehicles electronic control module to alter engine performance and enable the removal of filters, catalysts, and other critical emissions controls. In accordance with local laws and regulations, Bolt Motorsports will not ship parts to locations where usage or installation of said part would be in violation of the aforementioned acts.