Here’s a low cost, simple modification that will attract a little more attention towards your vehicle. It fits both the USDM and JDM grilles.

This pinstripe was inspired by a small Japanese shop that produces some pretty neat designs.

Comes with one full set.

NOTE:This is not generic pinstriping material that most sellers offer. It is custom contour cut to fit this specific application. Does not include S208 pinstripe, Subaru emblem, or STI emblem.

INSTALLATION

A wet installation is recommended for novices. With wet installations a mixture of soap and water is recommended. Use one drop of dishwasher soap in a cup of water, mix, and apply a SMALL amount to the grille, and pinstripe. Dry installs are not particularly difficult for this product either. You can align the pinstripe as you go and make small changes. Simply remove the pinstripe from the backing paper and apply it to the grille. Start with the area closest to the emblem. Work your way out to the corners. The material is stretchy, so if you stretch it a bit, you might need to use a credit card to push the ends down. Use hair dryer / heat gun as required with the wet installs. Allow to dry.