Add some unique styling with a minimum amount of effort and cost. Once applied, this product should last even longer than your car payments!

This is a vinyl product and has no actual carbon fiber content. Machine cut.This is NOT a universal product.The material has been cut down specifically for this application.

3D Carbon and matte black finishes are more resilient against scratches. While the black is much easier to work with than most black vinyl, please use extra care to not scratch it. Use a clean towel and an appropriate amount of wipe it down.

These install easily with a little water / soap. Clean the application area of your rear bumper. Leave a water / soap mixture on the surface of this area and apply the same mixture to the bottom of the overlay. This will make it easier to slide the overlay into position. Once even, squeegee out the remaining water / air bubbles. Be sure not to damage the material. Most of the time you can remove the bubbles with your fingers. Focus on the alignment of the visible edge of the vinyl. Contour the vinyl to the curve of the bumper. Allow 24-48 hours before washing vehicle.